@Hamst3rpaj I have the same. Have you fixed yours?
B
Posts made by Barto
-
RE: Heating failed! Cycle Power! FW v2.0.1.3posted in CR-6 SE /CR-6 MAX 3D Printer
-
6 SE hammers into bed on auto level and no heat on bed or nozzle.posted in CR-6 SE /CR-6 MAX 3D Printer
When I press auto level, the nozzle starts hammering into the bed.
If I try to set any heat levels it fails with following as an image on the display.
Heating Failed!
Cycle power! Target temperature was not met on nozzle or bed soon enough. Inspect and verify ambient conditions are suitable for .