Curious if anyone else is having issues get the ABL to work after flashing to this latest firmware? When I go into the Level menu, it will not let me click on the AUTO, only the AUX leveling appears and no screen change when I try to select the Auto bed leveling.

Hi All,

I was able to figure it out, I had updated Creality Slicer and it appears it now has a G29 command in the start G-Code for the CR-10 Smart profile. When I switched over to Cura 4.11 it no longer ran the auto bed level each time I ran a print. Still having issues with over extrusion after installing the all metal extruder. Switched all of the tubing to Capicorn as well. Might be a bent tube that is the short piece near the hotend.

Curious if anyone else has had this issue. I fired my printer back up after a month or so of non-use. Now when I try to print a file from either Creality Cloud or an SD card, it will just kick off the auto bed level and not print the actual file I am trying to print. Currently running F/W version 1.0.10. The only thing I have changed since the last time of using it was replacing the stock extruder with the all metal one, but wouldn't think that would have any impact on the actual proper printing of a file.

Curious if anyone else has had any continuious issue lik I have had with clogging. It seems I can run 1 print fine, then the next couple will produce a clog. Once I fully clean out the nozzle and hot end I can run 1 print just fine and then back to clogging. I've updated to the latest firmware successfully, 1.0.10. Tried a few different slicers (Creality Slicer, Cura, Prusa) with some different profiles but no luck getting it to print successfully on multiple prints without deep cleaning the nozzle.

I flashed the latest firmware CR-10 SmartMarlin2.0.6CRC2405V1.2Beta.zip to the motherboard and display. It seemed to take the firmware okay with no errors. But now when I go into Settings, Level, it goes to AUX. LVL. and does not let me select AUTO.LVL. Also noticing that in my About under Settings, I only show a F/W VER of 2.0.6 and nothing set for Screen Ver. or H/W VER.

Did I do something wrong in the firmware flash or is anyone else having this same issue after updating?

Curious if anyone else is having issues get the ABL to work after flashing to this latest firmware? When I go into the Level menu, it will not let me click on the AUTO, only the AUX leveling appears and no screen change when I try to select the Auto bed leveling.