@goombah88 Same here. Flashed the latest firmware just today. Extruder works just fine when I manually tell it to extrude some, but as soon as I try an actual print it seems to have stage fright and is just turned off the entire time. The X, Y & Z axis perform wonderfully, but the extruder is on vacation.
Best posts made by BrutonGaster
Latest posts made by BrutonGaster
RE: 📣📣CR-10 smart latest firmware has been unveiled
RE: CR 10 SMART Bed Level working?
@Korlbrien I had the same issue with not being able to get the ABL to work so I tried flashing the latest firmware today to both the motherboard and the screen. It appears that the ABL STILL doesn't work (because during a test print the nozzle was scrapping across the glass bed on the outer edge of the right side), and now, in addition to that, the extruder seems to be in a "forced-off" position during every print, so now I can't print anything. Any luck on your side since your last post?
RE: RE: CR-10 Smart Firmware Update
@sparks02 I had the exact same issue today - flashed the latest firmware (motherboard & display) and now it's like the extruder is just permanently turned off during all prints (now it's a $500 paperweight that makes noise). I'm a bit new to this, but does anyone have an idea how often Creality comes out with new firmware versions?