For some reason, when I went to hit preheat PLA, i saw that the nozzle temp wasnt coming up but the bed temp was (i had it set for 200/60 before). So i went to check the preheat pla settings and both temps are listed as 0. For PLA and ABS both.
After i entered my numbers and hit save, it would show up until i turned my printer off. When i turned it on again, it again would show 0/0 under preheat settings but it now actually went to 200/60. I vividly remember the numbers not being “0” before. It always showed my 200/60 settings.
Lastly, I am unable to factory reset. That button doesnt do anything for me. It just beeps, but nothing is actually done.
What is going on?