I heard you can use glue stick on the plate before you print. I have the same problem too and will try this out.

@dc88 I opened up switch this morning and it was burnt! I sent a note to the support. Hopefully I will get a replacement soon.

@dc88 please let me know how the new switch behaves... I hope that solves the problem. Then I can try the same too. I agree it's frustrating.

I think we can check if it’s a switch issue by bypassing the switch like this:

https://youtu.be/1zgcf3aD1x8

However I would like an official @admin answer before I go ahead and try that.

Charles

Hi @admin, I received my CR-6 SE last week and it has been printing okay for a few days. However, since yesterday, the machine shuts down whenever I tried to print. See the video below:

https://www.youtube.com/watch?v=gzlbAjeIbps

Is it a power switch issue?

I have also sent the video to kickstartersupport@creality.com with my backer # and serial #. Anything else I can do to help diagnose this issue?

Thank you,
Charles