When I power on my ender 6 and go to the home location, the carriage stays at its current place, moves a little to the left (2-3 MM) and moves to the rear, not the right rear home location without bltouch. With the bltouch installed, it moves to the left side of the carriage and slams into the left side. I have re-flashed with the firmware 1.0.1 for non-bltouch, and 1.0.2 for bltouch. The bltouch is disconnected when the 1.0.1 firmware is installed. When the bltouch is installed and 1.0.2 firmware, the bltouch powers on and flashes. It was working before this happened.