great!!!!

Hi, Im using V2 Black coated Bed. Sometimes prints don't stick, but if i run the same print again a few times they stick much better.
I believe that by printing the first layer a few times the bed cleans itself.
HOW do i clean the bed properly?
Is isopropyl alcohol 90% recomended?
Water and soap?
A dry cloth?

I can't find any official information. Online people have been using isopropyl alcohol 70% and a yellow stain would apear in their rags. I believe this could be the coating wearing off, since if you accidentally scratch the bed a yellow dust comes off.

Can you ask to your chemicals dealers what should we use?

Thank you very much!

great!!!!

Hi i have that problem too, i solved it with a bl touch and some smith firmware.
Also, some people recommend getting a few CD size aluminium foil discs in between glass and aluminium bed.
Not sure any of those would solve your problem, but you can try.

@admin thank you admin! I tried using water, but it doesn't remove PLA stuck on the surface. Is there any other product I could use?

On a side note, can I use hair spray on top of the black coated bed to make it more sticky?

Hi, Im using V2 Black coated Bed. Sometimes prints don't stick, but if i run the same print again a few times they stick much better.
I believe that by printing the first layer a few times the bed cleans itself.
HOW do i clean the bed properly?
Is isopropyl alcohol 90% recomended?
Water and soap?
A dry cloth?

I can't find any official information. Online people have been using isopropyl alcohol 70% and a yellow stain would apear in their rags. I believe this could be the coating wearing off, since if you accidentally scratch the bed a yellow dust comes off.

Can you ask to your chemicals dealers what should we use?

Thank you very much!

@dkfauth you get it to run on the dedicated port? how?

Hi, i have a bl touch and and a ender 3 v2. I don't have the adapter to plug the three pins and the screen on the screen slot, it didn't came wih it.
Is there a way to connect my bl touch to the bl touch port? Will there ever be?
Right now on the internet are firmware available that do this, but its not open source, and doesn't work great.
I would like very much to be able to do it with original creality firmware, which works much more reliably.