Hi has anyone found out how to do a Colour Filament change on the SE tried the usual route but doesnt seem to pick it up Thanks

Creality have brought out an all singing all dancing super printer auto leveling new extruder and nozzle all brilliant stuff but yet it cannot do a simple task of changing filament colour ( M600 ) can someone explain why this is not included and any plans to able this to work please Thanks

@admin if you puase the print how do you propose to remove the colour filament that is in it then ?
why cannot the machine just obey a simple M600 command like the Ender 3 does??

@admin if it does not support this can you tell me if there are plans ti update the software to enable it to work please thank you

@ncbob I await your results with eager antisipation

@ncbob ok no problem appriciate all the effort youer putting into this matter

What about the firmware update for the CR 6 SE that everyone is asking for when will that be available please

Its been quite a while now since I asked about the CR-6 SE update firmware to include the use of the M600 command amongst other things cad the ADMIN advise on when this is likely to happen please Many Thanks

I was asking about the update that will include the M600 command so to be able to do a colour filament change during printing as well as other thing that is supposed to be in development ??

@admin any news on when this will be ready for release please

@ncbob great stuff carnt wait

@admin any idea when that will be please
thank you

@admin thank you for that can you confirm that the M600 command has been added

@ncbob ok no problem appriciate all the effort youer putting into this matter

@ncbob I await your results with eager antisipation

@ncbob thank you for that but I wouldnt have a clue how to do it is it an add on for the slicer or for the printer itself thanks for all your help