Best posts made by davidzohar

@powerlines2000
I had a similar issue, not sure its the same but try this:
Control > bed leveling > Probe Z Offset > [use the dial to select the desired offset]
Go back and select 'Store settings' (scroll down to find it)
and once more Go back and select 'Store settings' (scroll down to find it)
Also, one thing that drove me nuts was that if you don't keep the SD card in the SD card slot your settings will be gone if you turn the printer off. So make sure that your SD card is in all the time, during settings and during print...
Hope this helps.

ok, i understand,
Where can I find the latest version for the Ender 5 pro firmware without the BLTouch?
its not that clear.
or do i need to get the BLTouch to get the latest firmware version?
currently my printer info state:
Marlin
Ver 1.0.1
2020-4-25
any help is appreciated.