My Creality Ender-6 is stuck at the boot screen with the white status bar.
It was working, I did a few test prints which did not turn out good due to the material won't stick to the glass. I turned it off for the night. In the morning I turn it back on and it is stuck on the bootup screen.
I download the 1.02 firmware and put it on the FAT32 formatted SD card and insert the SD card into the Ender-6 while it is unplugged. I plug in the power cord and turn it on, nothing, it is still stuck on the bootup screen.
Anything else I can do? Is my board bad?