I need help.
I received my printer and set everything up. Auto-leveled the bed, installed the filament, everything seemed fine. That is until I started to print.
The printer will go through the motions without filament being pushed into the nozzle. If I put pressure on the filament toward the filament sensor, the filament will come out. I've adjusted the screws to the stepper and made sure it was in the locked position, but nothing seems to help.
I have included a link to a video I shot showing the issue. This video is near the end of the print at 95%. I was attempting a test print of something I found on github.
I am new to this hobby, but willing to learn. I'm just not sure what to do next.