Now I have got myself in a pickle. How do you setup the autolevelling? My printer is determined to drive the hot end to Australia. I now have two holes in my bed where the printer has tried to level. Is there anyone out there that assist me? If not, the printer is going in the bin and I am off to find another make. What baffles me is that you cannot do anything with the autolevelling without autolevelling, unless I am missing something.

Failing any assistance, which 3D printer that has similar specs to this piece of rubbish do people suggest?

I gently rotate the filament axially as I pass it through the block. This is a bit fiddley but it seems to help. Also, I cut a bevel in the filament just so as there is a pointy bit. This is not required if you have previously removed the filament via the 'refuel' tool as you can trim the filament to the natural taper left by the process.

@Bizeek This is, I think, the answer. It seemed to be completely random at first and I thought that it may have been space on the disk too. Thanks.

My CR10S Pro has been working fine apart from bed adhesion in larger prints. I tried a glass sheet and the printer immediately scored lines, so I reverted to the original bed and tried again. Now the thing wont print properly and seems to be printing the raft all loose and not adhering at all to the bed. I have replaced the nozzle to no avail. Has anyone any ideas?

I am losing heart with this now. The printer just fails to acknowledge any GCode files I put on the SD card. I have used the Creality Slicer and Cura all to no avail. My only option, as I see it, throw this printer in the bin and find someone else's that does work. Unless, that is, someone has a solution as to what is going on. Are there settings? What?

A quick question, if I may. This happens seemingly randomly. I will download an STL file from say Thingiverse. I then get the Creality Slicer to do its thang. Take the uSD card to the printer, insert the card and turn on the printer. Then, nothing, the printer fails to see the file. This sends me into a rinse and repeat cycle to no avail. What am I doing wrong? I am finding it somewhat frustrating.