@Condormilan Did you check the voltage switch?
Best posts made by drumrgym
Latest posts made by drumrgym
RE: Problem with the first start-up after assembly
Cooling the printer nozzle & bed down before powering off [shutdown]
As much as I searched for a method to cool the nozzle off before I shut the printer down, I could not fine anything!
Here is a simple method I use.
Typically I eject the filament to stop it from cooling overnight with anything in the nozzle assembly.
Power Off and On in rapid succession, waiting roughly a second or two in the Off state.
Watch the nozzle temperature from the Home screen. It will start to fall.
Power off when cool.