@Starkiller said in need new firmware:
What does the firmware fix? or improve?
@admin you guys are ridiculously bad at answering questions and providing simple information. Makes me want to throw this thing in the trash. Got answers to these questions? I too am curious.
Is it brass?
I assume the extras they gave are the same type.
@admin said in CR-6 SE prints are not coming out, they are stringy:
DEAR @James-Garvin
Please refer to the video to clean the nozzle and throat. When installing the nozzle, tighten the nozzle first, then loosen 90 degrees, insert the Teflon tube to the end, and then tighten the nozzle
This did absolutely nothing for me. I'm still stringing like crazy. I'm going to experiment with a plated copper nozzle. The stringing issue is so bad, it makes this printer useless until its resolved
Is it brass?
I assume the extras they gave are the same type.
@admin where? what post? we aren't mind readers. give us the link to what you are talking about.
@Starkiller said in need new firmware:
What does the firmware fix? or improve?
@admin you guys are ridiculously bad at answering questions and providing simple information. Makes me want to throw this thing in the trash. Got answers to these questions? I too am curious.
@admin can you link what post you are talking about? Ive seen two replies mentioning it solved but not providing the link to which specific post you are referring to.