Posts made by enderlover

@Etienne Did you find a fix for this ?

What settings do you have do you under:
Settings > Move ?

Hi Friends,

At the moment i have a Ender 6 that was running good.
But i want to use some sort of bed leveling so i did add the BLtouch v3.1
I connect all the wiress and did a updrage to the FW: Ender-6-V1.0.4.9-BLTouch.
So far so good but when i press the leveling mode i cant use the Z+ of the -Z on the left side off the screen.
Also the BLtouch is blinking red.

I already tried:
-Other FW / Ender-6-V1.0.2-BLTouch
-Reconnect all the wired to the Bltouch
-Reset the Ender
-Downgrade to Ender-6-V1.0.1-Endstop then upgrade to > Ender-6-V1.0.2 then > Ender-6-V1.0.4.9.

Any help ?

Hope to hear from you guys !