@telephasic I was buy a 3.1, but not work corectly.. Firsttime printer was correctly, second print was terrible.. Not leveled, not print anything.. Printer start ** heating, after taht, eveling, after leveling start print, but status bar immediately show 100% and nothing happend.. I try it with more sliced models..
Best posts made by Etienne
Latest posts made by Etienne
RE: BL Touch connection
RE: Firmware for Ender 6 to support BL touch V3.1
@admin hi, i have installed BLTouch, but prineter not work correctly, many problem with Z axss.. for example, if i turn off prinetr, and put the bed lower, the printer start with x260 y260 z0 and with dissabled steppers.. when you go to settings and want to move, printer is not able to move because the x260 y260 z0.. for example if you want move Z it can't because printer think Z=0 and if you want move Z down, it's not abel to reach 400mm, printer start making annoying noise and stop.
another problem.. start print, printer heats up and start bed leveling, after leveling noting happend.. status bar go to 100% and you can only click on finish print..
RE: Ender 6 not booting up and stop when SD Card plugged in
try flash your firmware.. Download correct firmware here https://forums.creality3dofficial.com/ender-6/
if you dont have BLTouch download version without BLTouch, after that, unpack the rar, find firmware in folder mainboard, file have .bin suffix... rename that file to firmware.bin, copy this file on formated SD card to FAT32, safely remove the drive and plug it in to your prineter and hit on button, wait 50sec, until you se the menu.