Hi

Yes, there is an error in the drawing, the red and white wires are reversed, if you look on the back of the card there is the correct writing. I also had the same problem as you, luckily no damage, reversed the wires and it worked right away.

Yes, you also need to update the firmware and enable the filament runout , I installed marlin 2.0.7 and enabled the bl-touch as well.

Hi

Yes, there is an error in the drawing, the red and white wires are reversed, if you look on the back of the card there is the correct writing. I also had the same problem as you, luckily no damage, reversed the wires and it worked right away.