@admin add again the source code would be highly appreciated
guivo
@guivo
Best posts made by guivo
-
RE: CR-6 SE New Firmware Update 24th Nov
Latest posts made by guivo
-
Extruder gear replacement
Hi everyone, I am considering to replace the extruder gear, because it may start to wear. What are the parameter I should look for in buying a new one?
-
Filament holder with bearings
Hi everyone, I have designed a filament holder with bearings for my CR6. It seems to fix the large oscillations that the spool often has while printing, that I believe (with no real prove, I admit) can cause the extruder to flatten the filament, especially if it became a little brittle.
The link is here:
https://www.thingiverse.com/thing:4947656I hope it does something for you as well.
PS I think it fits other CR machines (CR-10 smart in example) but I cannot be sure.
-
RE: Mainboard versione on new Ender3 v2
@Gracy thanks, I was helping a friend and hoping he can avoid to open the printer or blindly upload FWs.
The mainboard chaos is quite difficult to sustain, makes difficult to suggest creality machines.
@admin should support in making this aspect more easily to recognize, in example just from the menu on the display.
-
Mainboard versione on new Ender3 v2
Which mainboard version is installed on new Ender3 v2?
-
RE: Continuous clogs
A different filament, not newer neither better kept, allowed the print to be finished.
However there wasn't a real clog. I just changed the filament and try to extrude the filament and there were no issues.
I believe that the filament, a geeetech silk pla, got a little brittle and the oscillations of the spool in retraction intensive parts increase the probability that the extruder ruin the filament, stopping the extrusion.
I will be doing some test, printing a new holder.
-
RE: Continuous clogs
@Gracy I have tried all the steps, not just once.
The weirdest thing that happens is the fact that I hear I little bang from the extruder, like a big missed step. Not sure if this is just the consequence or something in the extruder weakened overtime.
I have also tried replacing the original lock in the hotend with the one that comes with the capricorn tube, it went a little over, but I wasn't able to finish the model.
I will try with a different filament.
-
RE: Continuous clogs
@Gracy the filament is not brand new but it seems well kept, I'll try a different one to check.
Installing the Capricorn tube, I kept the original plastic holder, not sure this makes makes any difference.
-
Continuous clogs
My CR6 keeps clogging, I have been unable to finish any pla print in weeks.
The issue seems to be associated to parts that need a fair amount of retraction. I have also installed a Capricorn tube, with no benefit.
I have also tried increasing the hotend temperature. Any suggestion?
-
RE: What is this part?
I didn't have it but I would use it to help loading the filament, between the filament sensor and the extruder.
-
RE: Can't get Bowden tube out of hot end.
The bowden tunbe can be tough, is your hot-end warm? I usually do this operation while checking the nozzle, with the hot-end at 200+, depending on the material I was previously using. If there is some material between the end of the tune and the nozzle would be otherwise impossible to remove the tube.