I want to start off by saying this is my first 3D printer so my knowledge base on troubleshooting is very limited. I did a good amount of research into printer setup/adjustment and common issues people run into while doing the initial tune on a printer. So I am pretty confident that I have it setup and adjusted correctly. I have done somewhere around 15 prints and everything was looking good until my last print. I started to notice a vibration noise coming from one of the motors when the x axis would make slow movement’s. It only seemed to happen when the x was the only axis moving, the print was essentially a square so there aren’t any compound movements involved. I decided to watch the printer a little more and noticed one of the times I could see the bed vibrate along the y axis very quickly when I heard the noise. After seeing the vibration happen I stopped the print and checked over everything, as far as I could tell everything was adjusted/tensioned correctly and square (belts weren’t sagging roller wheels were snug while still spinning without to much resistance). So I don’t know if I have an actual problem or if it’s just something normal that I haven’t experienced yet but all of the prints have been without any major issues. If anyone has had this noise or could offer any insight please let me know.
Thanks in advance!