after a new board from creality, new cable new bl touch, still same problem
there response to me was its a good machine without the BL Touch. what a an utter joke.
i wont buy creality again
I finally got it working, it was a cable needed swapping. But after 2 Cables, 2 x BL Touches. it is not running a Bed Level, It tests fine, it then will either do 5 or 8 Points, then it just flashes red. I have reflashed right back to the first Firmware, flashed back to the latest, unplugging the power every time, removing the SD card. I get the same result from the Ender 6 or from octopi, in fact it goes further bed levelling with Octopi. Please can anyone help me
I have similar. All connects ok, does the Test, then when the bed comes up it crashes into the Nozzle. The BL Touch just then starts flashing red
Ive checked the Cables they are all find, if i reverse the white and black it just makes a horrendous Sound. Ive spent hours going through the internet but there is just no information available. I am really annoyed as i swapped out my Eryone Thinker for the Ender 6, The Eryone was flawless