change the filename if its contain special characters ...
now i use only letters
Best posts made by itlust
This user hasn't posted anything yet.
Latest posts made by itlust
RE: CR 10 SMART Bed Level working?
based on my experience with this very2 bad printer ...
- Check if your bed is wobbling ( move your bed to the front and check if its wobbling, move to the middle check again, to the back and check again ) (this is my main problem before)
- Check the gantry if its level enough
- based on your scr shot , are u connected to octoprint ? if not ,maybe you should flash your display firmware
Now, the ABL is work perfectly for me after months of frustation ...