I had to disassemble my Ender 6 because of a move, and when I reassembled it, I turned it on and it booted up until I pressed something on the screen and it shut off. Now I cannot turn it back on. It's on the correct voltage for the US, I tried multiple outlets, nothing. Does this mean the fuse is blown? I can't find any resources online about this. Thanks in advance!
Posts made by j9
Shut-Off and Won't turn back on
can't remove print
I am new to 3d printing and the ender-6 is my first printer, so I know this is a dumb question, but I haven't been able to find any specific help. I completed my first print, and it is IMPOSSIBLE to remove it from the bed. I waited until the bed and nozzle cooled down, and no amount of scraping will get it off. Is there something that needed to be put on the plate before printing that will help get the print off after? I used PLA+ filament at 210C and the bed was at 60C.
Any solutions for
- getting this stuck print off the bed, and
- what I should be doing in the future to be able to get the prints off?
Thanks in advance