I understand this frustration. My machine is brand new. It worked on day 1. Did some test prints. Worked fine. This morning, blank screen. Did some sleuthing and found an online solution. It fired back up! But, before I tried printing anything, I wanted to make sure it was still leveled and correct after the firmware flashing. Went to auto-home and it's stuck on the auto-homing mode too. I noticed that as of this morning (03.08.2021) there is a new firmware update for the LCD screen. Not sure if this is for the auto-homing issue or the blank screen. Any thoughts, ideas or fixes to get the auto-homing to finish it's procedure and not be locked up?