Why don't you just expose your git repo so people can do what they want and/or help? It's ridiculous.
jdelaney44
@jdelaney44
Best posts made by jdelaney44
Latest posts made by jdelaney44
-
RE: New Firmware update 14th November
-
RE: The 3 in 1 printer sucks so bad
Roger that. They say their stuff is upgradeable. It's not. They don't supply the firmware source files needed. Boooo! Very disapointed. This has been a change. They used to participate in the 3d printing community. If they think they can go it alone I think they will ver very surprised. Do they want to be Xerox or Harley Davidson?
-
DIY Upgrade PS to Mean Well - UHP-500-24?
Anyone tried replacing the stock PS with a Mean Well UHP-500-24 (no fans)? How did it work? Any pointers?
I am considering swapping out the stock RSP-500-24 with the UHP-500-24 which is fan less and thus noise less. I will also replace the case fan with a quieter Noctua or similar fan (lower air flow)
The UHP-500-24 has an open mesh cover and is supposed to be mounted on an aluminum plate that is 450mm x 450mm. The case of the CR-10S Pro is big enough but is steel & thus less conductive.
To take care of any excess heat I'm thinking of:
-
Add heatsinks to the top under the bed on either side of the belt
-
Add one or two fans at one of the front side vents
-
Worst case I could add more vent holes
It's a total experiment. Just wondering if anyone else has experimented with this too.
-