Hi All i seem to be having a few issues with my Ender 5 Pro.
It all started when i first began using it and it would only ever print like 2 minutes and then stop and display 'heat and change filament'. i unplugged the filament sensor and have since had no issues with this happening after 2 minutes. my issue now is that after approx 2.5-3 days of constant printing into a 6 day print, it comes with this same message even though i have plenty of filament on the roll (my sensor is still unplugged). before i waste another load of filament does anyone have any ideas for me to try?
Secondly my bed adhesion is poor, i have tried multiple methods such as kapton tape, glue but these either dont work or give me super bad finish on the bottom of my print. ideally i would like to be able to just print straight onto the heated bed. Im currently using regular 1.75mm PLA at a nozzle temp of 210 and bed temp of 60. any suggestions?