There are a couple of prints on Thingiverse to move the control panel to the Left but not sure about being able to move the extruder. The spool move is easy. In theory, you should be able to move the extruder over by flipping it upside down and moving to the right side. You'll need to get some wires and solder them in to increase the length of the lead to the main board. If you don't want to flip the stepper upside down, you'll have to reverse the inputs on the motor so it feeds the right direction.
Best posts made by Jollyroger
Latest posts made by Jollyroger
RE: How to move spool holder and control panel to opposite side
RE: ENDER 3 V2 Melted air duct.
I think this is for the Original Ender 3 or Pro but might work for you:
RE: Circle problems
Also make sure there's nothing (debris) caught up in the belt on the drive, idler or tension gears.
Try a temp of 205 and decrease speed to 50.
RE: Extruder leak
If you're running stock, check your bed leveling.
Some questions for a better answer though....
- What filament are you using?
- What temp is your bed and nozzle at?
- What speed/flow rate are you using?
- What hot end are you using?
- What extruder are you using?
Will help you the best I can.