The first thing i did was to upgrade to: Ender-3s1-hw24s1_301-sw-V1.0.5_C-CRTouch.zip
Then i followed the guide to use ABL and then adjust z-offset.
I have noticed that if i measure the distance to the bed after ABL and z-offset with a caliper.
Then i can reset the settings and do the same procedure once more then the z-offset is sometimes far from the initial value. I would expect to be approximately the same.
i.e there's a big difference from -2.7 to -3.10
The caliper is consistent but the values measured from the printer are always different.
I have not tested the resume after power outage and i have printed several times with PLA, PETG without any trouble.
What i do have trouble with is the progress information.
Cura says 8h 52min
The printer say: Printing time 0:25 and remaining time 0:0
Further in the process:
Printing time 1:34 and remaining time 15:38
When using OctoPrint the display locks.