I have an ender3 with 1.1.4 card.
I bought the creality bl-touch v 3.1 kit.
I installed firmware 126.96.36.199 provided by Creality.
I installed the set without any particular problems.
On the other hand ... Impossible to make the whole function correctly.
I have configured the Z-offset. Modified the gcode in cura.
When printing is launched, the bed leveling takes place.
then when printing the first 2 purge lines of the nozzle, we can clearly see a big difference between the start (almost unstuck) and the end of the line (crushed)
So I'm assuming bed measurements are not used when printing.
Does anyone have any idea on the source of my problem ...
Thank you in advance !!