Clean the printing bed with "spirit", don't know how this alcohol stuff is called. Use a small cloth with this stuff to clean it gently. And always do a careful leveling.

Hey Tim,
I had the same problem. Did you check that all axes are easy movable? So if it's powered off, can you move the heatbed and the hotend easily?
My fault was that the part which connects the threaded rod and the Z-motor was sitting directly on the z-motor, so it was too much resistance and couldn't move. Try turning the threaded rod by hand when powered off of stepper motors disabled.

And check the cable connections to the motors. Good Luck!

@guivo thanks, for me the vase mode also works if I use the connection via USB (@Creality put correct drivers on the SD card and on your homepage!). I'm thinking of using the Marlin FW instead of the creality one.. but first I wait a little bit more.

@guivo did you find an answer?

@Creality shame on you that you don't publish any instructions which firmware to use, if there is a new firmware without BL touch or whatever. I just want the fu**ing vase mode run without blobs, so get your sh*t done and publish a proper firmware, with proper naming and instructions.