Let me explain
Suppose I want 10 copies of the same print
But instead of printing all ten at once, one layer at a time I want to each item completely, then do the next
Can it be done?
Let me explain
Suppose I want 10 copies of the same print
But instead of printing all ten at once, one layer at a time I want to each item completely, then do the next
Can it be done?
I think I didnt explain my problem clearly
The finished print separates from the bed easily
But it not separate from the part
@gigor said in Brim wont release:
If so, you are probably too close to the bed on your first layer and it is squishing the layer into the bed too much.
Thats a good idea. I’ll check it when I get home.
Now I am not using either the brim or the raft and I like it much better. Printing is noticably faster and it uses less PLA
But someday I may need the other options so I want to know that I can
I’m using Ender 3 and the Crealty slicer. PLA 200c nozzle and 60c bed temp. I had no problems through many prints in the past but now the brim is stuck and wont release to the point of destroying the print
The USB cable that fits my Ender 3 8-bit 1.4 board does not fit the newer 32-bit 4.2.2 motherboard
What is the reasoning for that?
None whatsoever as far as I can see
@renatojd said in New Firmware update 14th November:
Same here. Also M300 is also been disabled so I can't get a tone for start and end print jobs. This is really sloppy work overall. Can we just get the Config.h and Config_adv.h files? I'll just recomile it myself.