new printer here ender 3 pro. i got my printer leveled and made a couple good prints. ran out of filament. switched to a new filament and it was sticking good after the temp adjustment then after an hour and ten minutes the base just comes unstuck. any suggestions? too hot bed? too cold?
M
madDad411
@madDad411
0
Reputation
3
Posts
1
Profile views
0
Followers
0
Following
Best posts made by madDad411
This user hasn't posted anything yet.
Latest posts made by madDad411
-
half way and the filament comes loose from bed
-
RE: first printing. What went wrong?
@madDad411 i leveled the bed using a piece of paper adjusted a few settings in the g code and its doing 100% better. had to go into advanced settings added brim and support type touching build plate no more worms.
-
RE: first printing. What went wrong?
I have the same problem. it doesnt stick to the surface it just gets pushed around very easily. maybe the base isnt getting to the right temp? also i cant calibrate my rpinter useing the software it says cant connect to printer. how do i connect computer to printer?