Are there any options for upgrading the CR-10S Pro V2 extruder to a direct drive extruder? I tried the BondTech kit but it requires the vref for the stepper motor to be around .4v. I have ruined 2 motherboards trying to adjust the Vref because the pentiometer on the motherboard breaks off if you get to around .6v.
Best posts made by miketurnbull67
Latest posts made by miketurnbull67
CR-10S Pro V2 Direct Drive
RE: Help Adjusting pressure sensitivity
@shinmai I have broken 2 of the trimmer potentiometers by trying to adjust the E1 Vref. I was using small ceramic screwdriver and doing very small turns. The top piece that the screwdriver goes into, breaks off. Anyway to fix without having to buy a new board?
Motherboard E1 Vref
I installed the DDX 3 v3 For Creality CR-10(S)Pro/Max and the instructions say that I need to adjust the VRef to .40. I have followed the instructions and I was able to get it down to .58 but as soon as I try to lower it any more the potentiometer breaks off. I purchased a new motherboard and the same thing happened. Is there a way to fix my motherboard?!
Newbie - Unable to get large prints to complete
I am new to 3D printing. Have a Creality CR10S V2. I have calibrated the e-steps, set the z offset, and leveled the bed. I can print calibration cube and benchy but when I try other larger prints I have issues. I just changed out the filament and put in a new bowden tube. I am using PETG with nozzle temp of 250 and bed temp of 90. Any suggestions?