I always keep the print bed at a minimum of 60 even with PLA. Sunlu PLA suggest a heated print bed. I would use a brim and heat the bed to 60. Watch the brim and adjust your Z offset to make sure you are printing close enough to the bed.
M
Mindstar
@Mindstar
0
Reputation
3
Posts
1
Profile views
0
Followers
0
Following
Best posts made by Mindstar
This user hasn't posted anything yet.
Latest posts made by Mindstar
-
RE: first printing. What went wrong?
-
RE: half way and the filament comes loose from bed
What temperature is your bed set at? What type of bed surface are you printing on?
-
CR-10 Max Swiss Hot End Cura Settings .06mm Nozzle
Does anyone have any suggestions for Cura settings for the CR-10 Max with a Swiss hot end and a 0.06mm nozzle? I read somewhere that you should increase the temperature settings by about 10 degrees for the Swiss hot end.
Thanks