not getting any response from your "professionals"

Just to keep you updated, I have also replace the board now, with a silent board.

I also wish to point out that it repeatedly happened that the printer "forgets" its position and tries to move beyond the limits

Hi @Yolanda, thank you for your response. That leveling procedure is what I did, literally the whole weekend. The result is ok-ish at first but it gets worse again after short time.

So I try it again with image urls

I've also made 3 autoleveling runs after another. Not turning any screws:

Looks like quite big differences to me

@SteveDee The files are 505 and 508Kb and when I try to upload them I get: Expected integer between 1 and 100 for quality but received 1000 of type number
thanks anyways

@SteveDee Per file or all files together?

The printer just managed to drive beyond Y, Z and probably X axis max points...
 

I executed "Measuring" from the leveling menu, then started a print job. Then this happened.

• What's the difference bitween the measuring process that I can't start in the menu and the one it does automatically before the print job? Do I need to do both?

this should be: What's the difference bitween the measuring process that I can start in the menu and the one it does automatically before the print job? Do I need to do both?

Are there any official instructions on how to level this printer? I have this printer for 3 weeks now and I'm unable to get it leveled. Also I have no clue in which order to do which levelling procedure. Initially I tried disabling "auto level" do the well known manual leveling with a sheet of paper, then enable "auto level" do the auto leveling, then do some fine tuning. But recently that didn't work anymore. I now have disabled "auto level" and tried to get it level only with the paper technique, I eventually had an acceptable result but when I did the same test print again the nozzle was again way to fare away. It was actually that far away so that the melted filament dropped onto the bed instead of printed and it did not stick either.

So I'm at an end with this printer. I'm unable to get it leveled and I have a lot questions reagrdin the leveling process:

• What's the correct procedure to level the printer with auoleveling enabled? Aux leveling first? do I have to disable the auto level function while leveling?
• When do I do the Z-Axis leveling? before I level the corners or after?
• What's the difference bitween the measuring process that I can't start in the menu and the one it does automatically before the print job? Do I need to do both?
• Do the numbers in the leveling menu tell me anything? Do they need to be in a certain range?