So I know that leveling the bed should solve this issue. I have leveled this bed so many times that I can do it in 5 secs. Time me.
So that being said, I still have an issue with my filament not sticking to the bed. I have not used any chemicals to clean the bed. Nor have I used any glue or adhesive. I have updated to the latest firmware. I checked the level of the glass. It's perfect except for a .005 lip on one of the very edges.
To start, I upgraded the springs, added a filament guide, added an Octoprint, installed a new extractor and tube, changed the nozzle to a higher grade, and added a 3d touch.
I have many prints without any issues. Then, for whatever reason, it just stopped sticking. Thinking it was some of the changes I had made, I started working backwards from the last "mod" I had made. I am now back to original. I have taken off all the "mods" and addons. The only thing that is not original is the firmware.
I have no idea where to go from here. Any help would be greatly appreciated.
MrTux
@MrTux
Best posts made by MrTux
-
PLA not sticking to bed
Latest posts made by MrTux
-
RE: Ender 3v2 PLA still not sticking to bed...
@mrog finally someone replies. Thank you sir (or mame). I was under the impression that if it got too hot that it was a bad thing. I have posted this thread in some other groups and they are all saying the same thing. I am getting some good and some bad results but it does appear to be a heat issue. Thank you for your reply. I'm working on it.
-
No support forum.....
T his forum is dead. A shame, it would be nice to have a support area for when things break or don't work on one of the most popular printers. Time to tell people not to buy anything from Creality.
-
Ender 3v2 PLA still not sticking to bed...
I am at my wits end. I have leveled this bed so many times its pathetic. I have changed everything back to original. I HAVE EVEN GONE BACK TO ORIGINAL FIRMWARE!!!!!!!
EVERY time I try to print, the PLA will not stick to the bed. I have not used any chemicals to clean the bed. I have only used a clean microfiber cloth. I have not used any type of adhesive or glue. Do I have to start using that?
I'm starting to give up hope that my printer will ever work again. -
PLA not sticking to bed
So I know that leveling the bed should solve this issue. I have leveled this bed so many times that I can do it in 5 secs. Time me.
So that being said, I still have an issue with my filament not sticking to the bed. I have not used any chemicals to clean the bed. Nor have I used any glue or adhesive. I have updated to the latest firmware. I checked the level of the glass. It's perfect except for a .005 lip on one of the very edges.
To start, I upgraded the springs, added a filament guide, added an Octoprint, installed a new extractor and tube, changed the nozzle to a higher grade, and added a 3d touch.
I have many prints without any issues. Then, for whatever reason, it just stopped sticking. Thinking it was some of the changes I had made, I started working backwards from the last "mod" I had made. I am now back to original. I have taken off all the "mods" and addons. The only thing that is not original is the firmware.
I have no idea where to go from here. Any help would be greatly appreciated.