A print failed due to a filament problem. Not sure why because the roll was not stuck in any way. Now I can't pass the filament through the hole (where the motor sits). the filament stops. It get around 2 cm in, I hear a click and blue light turns on. Never had this problem before. I can get it in the other way but from for the lower end (where it should go in) it stops like it's blocked in the inside.

Does anyone know how to fix this? This was not an issue first when I loaded it before.

Exactly the same thing happen to me. Done a couple of more prints without the problem. Now I set temperature manually and not use the automatic. So far so good.

@admin said in CR-5 Pro software recommendation:

will be a slicer comes with the machine, and it is slicer

Thanks I've installed that now!

Hi!
I have a problem with the CR-5 Pro that the heating of the pad sometimes turns off during printing, resulting in items to come loose and make the printing fail.

Has anyone else experienced this?

Please also add the CR-5 Pro as category

Hi!
I'm curious to know what software people are using together with the CR-5 Pro printer and the experience.

Kind Regards
Per Chr