Hello, I had issues with the previous firmware on my CRX, has the one being pushed out now been tested, or should I stick with the old one?
Thanks.
Hello, I had issues with the previous firmware on my CRX, has the one being pushed out now been tested, or should I stick with the old one?
Thanks.
@thesubmitter I think what you're describing is that the screen stays on and possibly the fan due to the power backfeed from the box. The easiest way is to cut a little 3mm x 15mm piece of electrical tape and cover up the power contact on the cable running to the printer. If you look at the USB connector that goes in to the box with the four contact on the lower side it's the one on the right. Then when you turn the printer off everything should go quiet and dark.
Just an update, the 3.02 app software is great, this is strictly a box firmware issue. I found the previous version of firmware from April and it works with CRX and the latest 3.02 app. I'm printing through the box again, creality is looking through the logs to see if they can figure it out.
@RedeyesXBL Never mind. Tried a different USB drive, it worked in 30 seconds or so.
@admin For those who got this to work, how long should it take after releasing the reset button to the flashing yellow light?
I updated my CRX-Pro to the latest firmware in the title and now the BL Touch only measures the size of an ender. Is there any way to correct this or go back to the original firmware?
Edit: I got the original firmware back on it and touch works normally again. Is there a revision list for the newer firmware? Does it fix anything? Is there a way to make it work properly if there is?
I had everything working, now after the latest box firmware / software update 3.02 ios it will not print to the CRX. It will not work either cloud slicing or transferring from Cura. It says it downloaded, but nothing heats up or moves.
Can I go back to the old firmware / software? The printer is fine, I am using the same file manually loaded to the SD card and the printer is using the gcode with no issues.
I have two boxes, the other one is hooked to an ender 3 pro and is working with no issues updated to the latest versions.
Please help!
I would be great if the app would let you transfer a gcode file to the device and send it to the printer.
It already lets me load a model from my iCloud storage, please add gcode files. I am ok with the app, I can save from the MacBook to iCloud. This would make the box much more useful and keep the creality cloud functionality.
Thank you..