This is a known issue and I have it on my unit. Heaps of folks are unable to resolve it. I've just about replaced all serviceable parts and run a PID tune with no luck. Creality, where are you?

Folks,

I've replaced the heating element, thermostat, and a new hot end. I'm still getting this error. It was happening before the nozzle temp hit230 now it happening just before it hits 220. I'm running the current firmware version too on the CR10 Smart.

This error is all over the internet and I cant belive Creality is ignoring it.

Hello Everybody!

It's always great coming into a new community forum. I need some advice on print quality and fine-tuning.

I test printed an XZY cube and it came out perfect - Whoooo. I'm now moving on to larger items it it looks like I may have some quality issues. I'm using PLA running 200 from the tip and 60 on the print bed.

What's some advice on getting improvements in this space? Is this the dreaded auto-leveling issue? What about raising the bed a little or adjusting the nozzle height?