Can anyone recommend a brand/color of PLA filament that matches the blue extruder and injection tensioner knobs on the Ender 3 v2?
R
rgoldino
@rgoldino
1
Reputation
2
Posts
1
Profile views
0
Followers
0
Following
Best posts made by rgoldino
-
PLA color to match Ender 3 v2 knobs?
Latest posts made by rgoldino
-
PLA color to match Ender 3 v2 knobs?
Can anyone recommend a brand/color of PLA filament that matches the blue extruder and injection tensioner knobs on the Ender 3 v2?
-
Transmission ratio not preserved across reboot
My Ender 3 v2 prints were coming out a bit short on the Z axis so I performed calibration and determined I needed to increase the default Z value from 400 to 415. I made this change through the control panel here:
Control -> Motion -> Transmission ratio -> Transmission ratio Z.
However, when I restarted the printer it went back to the default value. How do I preserve configuration changes? In case it matters, I am running Ender-3 V2-Marlin-2.0.1 - V1.0.2 firmware from the Creality website.