How about getting the .bin file uploaded for the new V1.0.3.6 ?
S7EN
@S7EN
Best posts made by S7EN
-
RE: CR-6 SE SOURCE CODE and Tutorial Video update
-
RE: CR-6 SE SOURCE CODE and Tutorial Video update
@admin No reply? Could you PLEASE upload a compiled ready to flash .bin File for the newer Firmware and for the Screen?
Latest posts made by S7EN
-
RE: CR-6 SE Nothing sticks anymore since 2.0.1.3
@guivo No i don't. I think it was a FW problem. I'll stay at 1.0.3.6 now because last print came out as good as before upgrading.
-
RE: CR-6 SE Nothing sticks anymore since 2.0.1.3
Thank you but as i wrote, i cleaned it with iso (isopropyl alcohol). I make this before every print.
The answer is, yes: The 2.0.1.3 forces to not use the mesh which was leveled before. I downgraded both screen and mainboard to 1.0.2 and then upgraded to 1.0.3.6 and everything workes fine again. 2 Days of work because of a firmware update let me think abaout ever upgrading again.
Thanks Creality for nothing
-
CR-6 SE Nothing sticks anymore since 2.0.1.3
Hi,
am i the only one which have problems with non-sticking prints since last update? I tried different PETG's and PLA's, dried one of them 6h, leveled the bed 100 times, tightened screws, replaced ptfe tube, cleaned the bed 100 times (with iso), flashed the firmware again (screen + mainboard), tried printing from sd-card and with octoprint and so on. NOTHING worked.
Can it be possible that the bed leveling mesh is not used anymore?
I tried downgrading to 1.0.3.6 but the screen does not respond. Has anybody downgraded successfully?
-
RE: CR-6 SE NEW FIRMWARE UPDATE
For those who have Problems flashing the Screen Firmware:
I also tried to flash with a 4k formatted 32GB MicroSD Card and it worked.
Is used MiniTool Partition Wizard Free for formatting.Thank you!
-
RE: CR-6 SE SOURCE CODE and Tutorial Video update
@admin No reply? Could you PLEASE upload a compiled ready to flash .bin File for the newer Firmware and for the Screen?
-
RE: CR-6 SE SOURCE CODE and Tutorial Video update
@ncbob Okay thank you, i do not flash newer firmware until it get's released for direct flash. The printer runs good with some litte bugs so i can wait.
-
RE: Gcode for turning on LED
Is there any other option to switch the light remotely? Maybe with octoprint?
-
RE: CR-6 SE SOURCE CODE and Tutorial Video update
@ncbob Is it worth it? I mean, whats better?
-
RE: CR-6 SE SOURCE CODE and Tutorial Video update
How about getting the .bin file uploaded for the new V1.0.3.6 ?