@Helium3 yeah that would be nice! Thank you for the help!! i also noticed that the filament was leaking around the nozzle i cleaned it up and tightened it and it seems to be better now
Best posts made by sanhiram
Latest posts made by sanhiram
RE: Z axis issue
@Helium3 Thank you, ill try turning it half way back to see if that helps, I have the ender 3 V2. its just a string of filament but it kinda curls into the nozzle tip and it get stuck and sometimes the initial print line does not clear it so when it actually starts printing my design the excess filament thats stuck around the nozzle with mess it up
Z axis issue
Any time i go to print I auto home first and then hit print. my printer will re auto home itself after I hit print and then immediately raise itself up about 4 inches until its ready to print then it will come back down and begin printing. the issue is that while its raised all the filament will start to drip out and sometimes it makes a mess and will mess up the initial print.
Im thinking this is an issue with the Prusa slicer i am using, maybe a preset? it didnt do it with the files that came on my memory card but has done it with any file i print from thingiverse/prusa slicer.
I cant find the setting on the slicer program
Issues with the temperature setting.
I'm having an issue with my nozzle temp. when I click "preheat PLA" it is set to heat up the nozzle to 200 (it does this fine) however, as soon as I click on a file to print it the temperature automatically changes itself to be set to 150 and sometimes a few seconds after that it will reset it self but back up to 205 so I have to go in to "tune" and set it back to 200 every single time after I hit "print"
any ideas why this could be happening?
This is my first printer so I am very new at this!