@julfr2 change the bed settings in cura printer machine.. Mabey they are set to with 220x220x250
seven1964
@seven1964
Best posts made by seven1964
Latest posts made by seven1964
-
RE: Ender 3 3D won't start printing anything
-
RE: Ender 3 3D won't start printing anything
@julfr2 remove printer from cura, restart cura and install printer again, then try again.
-
RE: Z-axis not raising during print
I know this can happen when the voltage settings are incorrect.
X-As: 1,22 volt
Y-As: 1,25 volt
Z-As: 1,22 volt
E-As: 1,39 voltHere is a link that explanes this.
Its in dutch, but you can translate it to english.https://www.123-3d.nl/page/Creality_3D_Ender-3v2_vRef_Instellingen.html
cheers
-
RE: prints about a 1/4 inch above the bed
@spartacus
I had the same problems.
What i did was i remover the printer in cura
And after cura restart i installed the printer again
That worked for meEnder 5 plus.
cheers
-
How to solve this petg issue
Hi,
I'm new to 3d printing and got my ender3 v2 just couple month.
Yesterday i installed the cheap ($28) direct drive from banggood.
I must say all looks good , only it warps on the bed.
What to do to prevent this?As you see on the pictures, the print went out pretty good for petg filament i guess.
No stringing or so.