Hi all,

I already found the problem, the extruder did not stretch the filament enough and that is why the melted filament did not fall and did not stick to the bed and when it fell it fell without force.
I have tightened the screw of the extruder and it pulls with more force and it falls correctly.
Thank you

Hi all,
I have a problem with printing and I don't know why? Suddenly, I do not remember making any changes at the printer level, the prints began to not stick to the bed, layers are left without putting the print, the parameters are those of the cure profile for creality cr-6 se.
I have updated printer firmware and reinstalled cure several times and use diferent filament.
!


Thanks.

The problem is solved.
Topic can be close.

I have a cr6 se and bought some rolls of filament, one of the rolls when passing the filament through the sensor and trying to put it in the extruder does not go in, the fialment is pla of 1.75, it is as if it ran into something that does not allow the filament inlet