@telephasic I reseated the cables on the printer several times and saw no problem with the stepper motor. I don't think I missed anything surging observation. If I auto level without the SD card I have no issues at all, but I can't save my settings. If it was the motor would it not happen all the time and not just when the SD card is used? Also Is there a way to save my eeprom to the mainboard? If not is there a part number for the SD card reader or a similar part in another type of machine? I will start by replacing the reader. I can return it if it's not needed.
S
slender ender
@slender ender
0
Reputation
4
Posts
1
Profile views
0
Followers
0
Following
Best posts made by slender ender
This user hasn't posted anything yet.
Latest posts made by slender ender
-
RE: Ender 6 leveling position issues (auto leveling and prints go diagonal due to sd card eeprom)posted in Ender-6
-
RE: Ender 6 leveling position issues (auto leveling and prints go diagonal due to sd card eeprom)posted in Ender-6
@telephasic I tried a new SD card and the issue occurred again. I am thinking 2 things. 1 is that there a problem with the firmware that handles my eeprom on the board. 2 the SD card reader or lcd is bad. This only happens with the SD card inside the SD card slot. It also happens with both the BL touch and end stop sensor. Do you know where I can buy either the SD card slot, SD card cable, or the lcd?
-
Ender 6 leveling position issues (auto leveling and prints go diagonal due to sd card eeprom)posted in Ender-6
Hello Creality comunity I have an Ender 6 with a few issues. I recently had issues leveling my points wether it be the 5 points with the end stop or if I used my BL touch for the 5 point or 25 point auto leveling. It goes in a diagonal pattern even if I am printing. I just started seeing this as of 2 weeks . I had the printer over a month and didn't know what it is that caused it. I found out after trial and error my SD card seems to be the reason. I need to save the e eprom on the printer itself to fix the issue. Can anyone help figure this out? Also want to know does anyone know if there is any code I need to edit or any file to fix this issue? I will leave a link with the video below.
Thank you creality comunity in advance.
-
RE: Ender-6 / With BL touch v3.1 errorposted in Ender-6
@enderlover I had a similar issue. I had remedied the blinking light by homing it first. I then found out that the bed only moves at like 0.1mm so it feels like it's not moving, but it's just very little steps. On the motherboard there is a micro USB port. You can use pronterface It is for editing the printers axis and other settings.