Best posts made by StarLog

@roeland said in Cr-6 SE - USB connection:

After I connected my desktop via a USB cable to the printer, BOTH THE PRINTER AND MY COMPUTER DIED. I have no idea how a USB cable connection could even do that, but it happened anyway. I've asked Creality support to help me and have sent my computer to a repair shop.

I was running the firmware the printer was delivered with. Needless to say, I'm very unhappy at this moment... I was getting the hang of getting some nice prints and now this...

My suggestion: Do NOT connect the printer via USB, unless Creality guarantees it is safe to do so.

Mine did the same thing, on the main CR-6 board SMD Fuse F3 and SMD chip U9 were both burned.

I downloaded and installed the Dec. 3rd 2020 firmware, but it comes up in Chinese.
Did I get the wrong version from them.?

03 Dec, 2020
CR-6 SE Upgrade Package V2.0.1.3_202012.7z

@357bob said in PC access:

Received my box today. Set up was a breeze. Using is a bit clunky. Seriously lacking the ability to upload models directly from PC. The only work around I've found it to email it to myself, open it on my phone and proceed from there. Any have a better way, please share.

This issue needs to be addressed. I do not work from my phone with models.
Please make it so we can access the box from our pc.