Topics created by StarLog

@ironside said in CR6-SE firmware seems in Chinese: do I unzip it and put that folder on the rood of the sd card yes I've formatted the card according to instructions and I've used 2 different cards with same result I would still double-check this. Maximum 16GB card (unless you FOR SURE know what you're doing, and repartition the card to make the correct allocation size possible) formatted to FAT32 and 4096 byte allocation size. Also use a GUI unzip program and unzip the DWIN folder directly to the SD. Copying the files around by hand with some file-managers will mess up the file names making for an incomplete update. Some users have reported that re-naming the problematic files works, too, but haven't tested that myself, so YMMV.

You can upload your models to Creality Cloud by website: model.creality.com

OK Then thanks

Well it smoked, and the parts that burned on the mobo are U9 near the USB port and Fuse F3. This is bad USB circuit, as when I got close to the shield on the USB and plugged in my PC USB cable, I noticed sparks. Then tried again no sparks, 28 hours later I was going to print via USB and then it smoked. This can be fixed easily with a replacement mobo. and redesign of the board USB.