Filament not feeding. I just received my second CR-6 SE (1st one was DOA) and the filament will not feed. If I push the filament after heating the nozzle. I get a little to squeeze out. Other than not it will not feed. I also have the problem of the filament being hard to load. I can get to through the sensor then it is extremely hard to push it through. Are these related? How can I fix it so I can start printing.
tampat
@tampat
Best posts made by tampat
-
Filament not feeding
Latest posts made by tampat
-
RE: CR-6 SE will not read any SD Cards
I am having the same issue and would like to know how to use the Micro SD affixed to a computer so I can bypass the SD. If I pull the SD card out slightly it works. But, it is a pain in the patooty.
-
RE: New to 3D Printing - Filament not being fed during print
@dermaestro I am having the same issue. Was this resolved?
-
Filament not feed from the hot end.
Filament not feeding. I just received my second CR-6 SE and the filament will not feed. If I push the filament after heating the nozzle. I get a little to squeeze out. Other than not it will not feed. I also have the problem of the filament being hard to load. I can get to through the sensor then it is extremely hard to push it through. Are these related? How can I fix it so I can start printing,
-
Filament not feeding
Filament not feeding. I just received my second CR-6 SE (1st one was DOA) and the filament will not feed. If I push the filament after heating the nozzle. I get a little to squeeze out. Other than not it will not feed. I also have the problem of the filament being hard to load. I can get to through the sensor then it is extremely hard to push it through. Are these related? How can I fix it so I can start printing.