Hello all,
I just assembled my new ender 6, but when I home the printer, the bed moves down a little then doesn't move. The hotend homes fine. Also, I think the z motor may be inverted because when I move the bed up in the firmware, the bed moves down. I checked all the wires and they're all fine (I did connect the z motor at the bottom). Any ideas?
T
tartpickle
@tartpickle
0
Reputation
3
Posts
3
Profile views
0
Followers
0
Following
Best posts made by tartpickle
This user hasn't posted anything yet.
Latest posts made by tartpickle
-
Ender 6 z axis inverted?
-
Leveling nightmare (Ender 3 V2)
Hello all,
I'm currently trying to level my bed, in one spot (the middle-back) it's too tight and rips the paper and I can't figure out how to lower it. Also, if I try to home the printer, the X axis tries to go back to far and makes a terrible loud noise. Someone please help me :D. -
Leveling nightmare
Hello all,
I recently got a new PEI bed for my Ender 3 V2, I tried leveling the bed (for the first time) and in the middle of the back it was way too tight. It was ripping through the paper and I couldn't figure out how to lower that area. I also tried homing it to try again, but it was moving the bed back farther than it actually could. Someone please help me if possible, thanks :D.