Just got a Halot one and there are a few pain points for me that id like to see addressed in a firmware update.
-
when pausing the print it would be nice to be able to lift the build platform. having to wait an hour to 2 hours before being able to see if a part is actually still attached to the supports is ridiculous.
-
the ability to set exposure times, lift , bottom layer etc settings within lychee/halot box would be amazing. at this point in time i have to write all my settings down and then manually punch them in when changing resins rather than just doing it all from within the slicer...
-
with regards to changing the printing parameters on the printer itself (exposures/bottom layers etc) this menu really needs some buttons on either side of the sliders to increase or decrease the settings. for example when i try to adjust the exposure time i would often end up a 2.6 or 2.9 but i needed to be at 2.8. if i could just tap a button to reduce/increase it by 0.1 sec increments it wouldnt be as frustrating
-
it would be nice to have the clean button have a timer on it. that way its not left on for too long.