Old guy new to all of this.

I have had the printer for 3 weeks. I'm impressed by the way it is put together. There are a few small build quality problems that were overcome and started the learning curve that comes with 3D printing. Bed leveling an ongoing problem; several prints stopped after the first layer but ended up with a complete rabbit. And if I do say so an impressive rabbit.

My current problem is that I have noticed the Parts Cooling Fan has stopped running. The fan works with a separate power supply but no power from the control board in print mode. Firmware or board failure? Would appreciate feedback.

I will read all of the leveling comments in the forum. It seems to not come back to the same place twice when leveling.

PS Meanwell power supply, Firmware Ver 1.70.2bl